Figure 2.6 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual

Page 65

Text mode
Original mode

Publication AG-UM008C-EN-P - February 2005

Configuring Enhanced PLC-5 Processors 2-27

Figure 2.6 Example of a PLC-5 Write MSG to Another PLC-5

(or SLC 5/03, 5/04, 5/05, MicroLogix 1100/1200/1500, or Logix) Processor

This MSG example tells this (master) PLC-5 to write the information
from its file N19:0 through its serial port (channel 0) to the PLC-5
(slave) station 13

. The data’s destination is N7:0 of the PLC-5 (slave)

station.

Ladder Rung

Control Block

MSG being sent to another
PLC-5 processor.

MSG being sent out channel
0 (must use MG file type).

If the destination were a
Logix processor, then the
address could also be
entered as “tagname”.