Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 11)

Publication AG-UM008C-EN-P - February 2005
Table of Contents 7
DATA-LINC Group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-23
SRM6000/6100/6200E . . . . . . . . . . . . . . . . . . . . . . . . . . 8-23
SRM6000/6100/6200E-SLC . . . . . . . . . . . . . . . . . . . . . . 8-25
SRM6000/6100/6200E-PLC . . . . . . . . . . . . . . . . . . . . . . 8-27
Electronic Systems
Technology (ESTeem) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-29
Microwave Data Systems (MDS). . . . . . . . . . . . . . . . . . . . . 8-35
MDS Model 2100 and 4100 Master Stations . . . . . . . . . . 8-36
MDS Model 2310 and 4310 Remote Stations . . . . . . . . . 8-37
MDS Model 9810 Spread Spectrum . . . . . . . . . . . . . . . . 8-38
Power Line Modem
Configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-39
DATA-LINC Group . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-39
LCM100 Line Carrier Modem . . . . . . . . . . . . . . . . . . . . 8-39
Chapter 9
Configuring RSLinx Classic
Software for DF1
Half-Duplex Communications
Chapter Objectives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-1
Configuring RSLinx Classic Version 2.x as a Master Station . 9-1
Configuring RSLinx Classic Version 2.x as a Slave Station . . 9-10
Chapter 10
Using Dial-up Telephone
Communication Chapter Objectives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-1
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-2
Setting up the System . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-3
Configure the Processor . . . . . . . . . . . . . . . . . . . . . . . . 10-3
Configure the Modems for the PLC-5, SLC, and Logix
Processors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-3
Configure the Modems for MicroLogix 1100/1200/1500
Controllers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-4
Communicating Over the Telephone Line . . . . . . . . . . . . . 10-4
Initiate Modem Dialing. . . . . . . . . . . . . . . . . . . . . . . . . 10-5
Verify Connection to the Remote Modem . . . . . . . . . . . 10-6
Transfer Data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-7
Disconnect the Telephone Link . . . . . . . . . . . . . . . . . . 10-7
Peer-to-Peer Communication . . . . . . . . . . . . . . . . . . . . . . . 10-8
Report-by-Exception and/or
Master Station-Initiated Communication . . . . . . . . . . . . . . . 10-9
Chapter 11
Remotely Program Allen-Bradley
Processors Over a Telemetry
Network Chapter Objectives . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-1
Remote Programming via RSLinx® Gateway™ . . . . . . . . . . 11-2
Remote Programming via SLC 5/05 Ethernet to
DF1 Passthru . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11-4
Remote Programming via Logix EtherNet/IP to DF1 Bridge . 11-7