Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 264)

Publication AG-UM008C-EN-P - February 2005
7-38 Configuring Logix Controllers
Logix Controller Error
Codes for PLC and SLC
Messages With the release Logix R10.x firmware, you will find new error code
values for errors that are associated with PLC and SLC message types
(PCCC messages).
•
This change lets RSLogix 5000 software display a more
meaningful description for many of the errors. Previously the
software did not give a description for any of the errors
associated with the 00F0 error code.
•
The change also makes the error codes more consistent with
errors returned by other controllers, such as PLC-5 controllers.
The following table shows the change in the error code values from
R9.x and earlier to R10.x and later. As a result of the change, the .ERR
member returns a unique value for each PCCC error. The .EXERR is no
longer required for these errors.
R9.x and earlier R10.x and later Description
.ERR .EXERR .ERR .EXERR
0010 1000 Illegal command or format from local processor
0020 2000 Communication module not working
0030 3000 Remote node is missing, disconnected, or shut down
0040 4000 Processor connected but faulted (hardware)
0050 5000 Wrong station number
0060 6000 Requested function is not available
0070 7000 Processor is in Program mode
0080 8000 Processor’s compatibility file does not exist
0090 9000 Remote node cannot buffer command
00B0 B000 Processor is downloading so it is not accessible
00F0 0001 F001 Processor incorrectly converted the address
00F0 0002 F002 Incomplete address
00F0 0003 F003 Incorrect address
00F0 0004 F004 Illegal address format - symbol not found
00F0 0005 F005 Illegal address format - symbol has 0 or greater than the maximum number of
characters supported by the device
00F0 0006 F006 Address file does not exist in target processor
00F0 0007 F007 Destination file is too small for the number of words requested
00F0 0008 F008 Cannot complete request
Situation changed during multipacket operation
00F0 0009 F009 Data or file is too large
Memory unavailable
00F0 000A F00A Target processor cannot put requested information in packets
00F0 000B F00B Privilege error; access denied