Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM - Manual (Page 199)

Publication AG-UM008C-EN-P - February 2005
Configuring SLC 500 Processors with 1747-KE Interface Modules 5-13
Point-to-Multipoint Link Configurations
In the PLC-5 processor, create integer files that correspond to the
station addresses of the SLC 5/02 processors that will be sending
messages to the PLC-5 processor. Because, when an SLC 5/02 sends a
MSG instruction to a PLC-5 processor, the SLC 5/02 processor reads
data from and writes data to a PLC-5 integer file that is equal to the
SLC 5/02 processor’s DF1 station address.
Point-to-Point Link Configurations
In the PLC-5 processor, create and make available the file that
corresponds to the DH-485 node address of the SLC 500 processor for
SLC 5/02 read and write messages.
Example MSG Control Blocks
For application See On page
SLC 5/02 write message to a PLC-5 processor Figure 5.7 5-14
SLC 5/02 read message to a PLC-5 processor Figure 5.8 5-15
SLC 5/02 write MSG to an SLC 500 processor Figure 5.9 5-16
SLC 5/02 read MSG to an SLC 500 processor Figure 5.10 5-17