Configuring logix controllers, Chapter objectives, Chapter 7 – Rockwell Automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM User Manual
Page 227: Chapter objectives -1, Chapter
1
Publication AG-UM008C-EN-P - February 2005
Chapter
7
Configuring Logix Controllers
Chapter Objectives
This chapter helps you set up a Logix (ControLogix, FlexLogix, and
CompactLogix) controller as a master station, as a slave station, or as a
station on a point-to-point link.
For information about:
See page:
an overview of the tasks required to configure a Logix controller
installing the controller
using modems that support DF1 communication protocols
configuring the controller to use the serial port
modem control line operation
configuration considerations for RTS send and off delays
configuring a standard-mode DF1 half-duplex master station
configuring a master station for standard polling mode
DF1 half-duplex master diagnostic counter
configuring a message-based mode DF1 half-duplex master station
configuring a master station for message-based polling mode
configuring the controller as a slave station
configuring slave poll timeout
DF1 half-duplex slave diagnostic counters
configuring the controller as a station on a point-to-point link
DF1 point-to-point diagnostic counters
accessing DF1 diagnostic counters
messaging
example MSG control blocks
logix controller error codes for PLC and SLC messages