Apple Soundtrack Pro 2 User Manual
Page 41
Chapter 2
The Soundtrack Pro Interface
41
 Arm for Recording button: Enables (or disables) the track for recording when you click
the Record button. Only tracks have Arm for Recording buttons, not busses or submixes.
 Mute button: Mutes (or unmutes) the track, bus, or submix.
 Solo button: Solos (or unsolos) the track, bus, or submix. Soundtrack Pro supports
both multiple solo and exclusive solo.
 Envelopes disclosure triangle: Shows the track, bus, or submix envelopes in the area
directly below the track.
 Volume slider: Sets the track, bus, or submix relative volume in the overall mix.
 Submix pop-up menu: Choose a submix for the track or bus from the menu. (Tracks
and busses only.)
 Input Device pop-up menu: Use the Input Device pop-up menu to choose the recording
input device, and its Channels submenu to choose the channel (or set of channels).
 Input Routing buttons: Use the Input Routing buttons to confirm or change recording
input signal routing.
 Output pop-up menu: Choose the physical outputs for the submix from the menu.
Submixes only. (Not shown in the illustration.)
 Panner: Sets the pan position of the track or bus. Has two modes: stereo slider or
surround panner. Appears in track and bus headers only, not in submix headers or
the Master bus header.
Note: The Input Device pop-up menu and Input Routing buttons are visible only when
the track height is set to Medium or Large.
For detailed information on using the track controls, see “