Apple Soundtrack Pro 2 - Manual (Page 350)

350 Chapter 11 Working with Audio Effects
Choosing the Bus to Which a Send Is Routed
When you add a send, the audio is routed from the send to a bus. By default, the first send
you add to a track is routed to Bus 1, the second send is routed to Bus 2, and so on, if the
bus exists. Once you add a send, you can choose the bus to which the send is routed.
To choose the bus to which a send is routed, do one of the following:
m In the Effect Parameters area of the Effects tab, choose a bus from the Send
pop-up menu.
m In the Mixer, control-click an effects slot in the channel strip, choose Add Send from the
shortcut menu, then choose one of the available busses in the submenu.
Note: If no bus exists, the menus will read “Unconnected.” You must first create a bus
by choosing Multitrack > Add Bus.
Adjusting Send Volume
You can adjust the volume level for the audio routed through a send.
To adjust send volume:
1 If the send volume slider is not visible, click the disclosure triangle for the send.
2 Drag the send volume slider left to lower the volume level, or drag it right to raise the
volume level.
Add Send button
Send pop-up menu