Apple Soundtrack Pro 2 - Manual (Page 351)

Chapter 11 Working with Audio Effects 351
Adjusting Send Pan Position
You can adjust the pan position for the audio routed through a send.
To adjust send pan position:
1 If the send pan sliders are not visible, click the disclosure triangle for the send.
2 Drag the send pan (x) slider left to pan the send to the left, or drag it right to pan the send
to the right. Drag the pan (y) and pan (lfe) sliders to adjust the surround pan settings.
Note: For information on surround panning, see Chapter 9, “ Mixing Surround Sound ,”
on page 293.
Reordering Sends
You can reorder sends in the Effects tab or in the Mixer.
To reorder a send:
m In the Effect Parameters area or in the Mixer, drag the send up or down in the list to
change its order.
Bypassing Sends
You can bypass a send. When you bypass a send, the audio is not routed to the bus for
the send, and is not heard.
To bypass an effect:
m In the Effects tab, deselect the checkbox next to the send.
Automating Realtime Effect Parameters
You can automate realtime effect parameters using envelopes. When you automate an
effect parameter, you can change the value of the parameter over time. You are
basically “recording” effect parameter changes into parameter automation envelopes
that can then be edited and re-recorded. For more information about automation, see
Chapter 12, “
Working with Automation ,” on page 355.
Automation-enable
checkboxes