Figure 135: the toggle number in the action list, Figure 133 – Kramer Electronics WP-501 User Manual
Page 83

78
K-Config - Using the Triggers
Figure 133: Button Trigger Properties Window (Activate while Pressed)
Toggle 1-2-3-4: select the number of toggle states (from 2 to 10). With each press of the button, the next toggle is
activated (upon completion of that toggle). When in the last toggle, the next press of the button will activate the
first toggle once again. We recommend that you assign a button color command to each trigger so that you can
identify each toggle by the color of the button.
For example, the toggle button could be set to have two states and used as an on/off switch. The first press of the
button will trigger
an “On” action list. The next press on the same button will trigger the “Off” action list.
Note that not all room controllers can have up to 10 toggle states, some have less
shows the toggle behavior window:
Figure 134: Button Trigger Properties Window (Toggle 1-2-3-4)
When selecting the Toggle option, a sequence of actions is written for each toggle, as appears in the Action List:
Figure 135: The Toggle Number in the Action List
States: select the number of states from 2 to 4. The state of the button can be changed through Panels Status in
the Action Editor