1 setting the ethernet connection – Kramer Electronics WP-501 User Manual
Page 123
118
K-Config - Connecting to the Device
10.1.1.1 Setting the ETHERNET Connection
You can connect the device (for example, the SV-551) via Ethernet using either of the following methods:
Directly to the PC using a crossover cable
Via a network hub, switch, or router, using a straight-through cable
Connecting the ETHERNET Port directly to a PC (Crossover Cable)
You can connect the Ethernet port of the RC device to the Ethernet port on your PC, via a crossover cable with RJ-45
connectors.
This type of connection is recommended for identification of the factory default
IP Address of the RC device (192.168.1.39) during the initial configuration.
After connecting the Ethernet port, configure your PC as follows:
1.
Click Start > Control Panel > Network and Sharing Center.
2.
Click Change Adapter Settings.
3.
Highlight the network adapter you want to use to connect to the device and click Change settings of this
connection.
The Local Area Connection Properties window for the selected network adapter appears as shown in
Figure 210: Local Area Connection Properties Window
4.
Highlight either Internet Protocol Version 6 (TCP/IPv6) or Internet Protocol Version 4 (TCP/IPv4)
depending on the requirements of your IT system.
5.
Click Properties.
The Internet Protocol Properties window relevant to your IT system appears as shown in
or
i