2 creating an ir command, Figure 69: testing serial commands, Successful response – Kramer Electronics WP-501 User Manual
Page 45: Figure 70: testing serial commands, Response failure
40
K-Config - The Driver Manager
– Getting Started
Figure 69: Testing Serial Commands
–Successful Response
If the device fails to respond, an ERROR, TIMEOUT message appears:
Figure 70: Testing Serial Commands
–Response Failure
5.5.2
Creating an IR Command
You can add an IR command in the same way as described in
Section
or read the IR command via IR Learning
as described in this section.
To create IR commands for a selected device, connect the RC device (with IR learning capability) directly, whether it is
defined as an auxiliary device or a Master device, to your PC and use the remote control transmitter to learn its IR
commands.
Use the remote control transmitter of the machine from which you want to learn the IR commands. For example, use the DVD
remote control transmitter to write the DVD commands to the driver manager
To create an IR command:
1.
Connect the device directly to your PC.
2.
Select IR>Non-Shared and click + to add a command. The following window appears:
3.
Type the new comman
d’s name and click OK.
The new command (for example, ZZZ) is added to the non-shared list: