Figure 11: change the working directory window, Figure 12: drive database loaded, Figure 13: installation complete – Kramer Electronics WP-501 User Manual
Page 14: Figure 11

K-Config
–
Kramer K-Config Software Installation
9
Figure 11: Change the Working Directory Window
6.
If you need to change the working directory, click the Browse For Folder button, select the working directory
and click OK.
If you do not need to change the working directory, go to the next step.
7.
Once the working directory is selected, click the Set to Default Location button.
If a previous version of K-Config is installed, the drivers are already uploaded
Figure 12: Drive Database Loaded
8.
Continue to run the setup according to the installation instructions.
The following Window Appears:
Figure 13: Installation Complete
9.
Click Close to complete Installation.