Kramer Electronics WP-501 - Manual (Page 106)

K-Config – Adding Actions to a Trigger 101
4. Click the Add to List button.
The command is added to the Action List area (the trigger name appears at the top of the list):
Figure 180: The New Command in the Action List
5. In the same way you can use the Action Editor to add further commands to the action list:
Figure 181: The Action List for the All On Trigger
You can: Delete an action
Duplicate an action
Move actions up or down
Once a Trigger ’s action list is assigned with commands, it turns bold:
Figure 182: The All On Trigger (after adding commands to the action list)