2 adding a port command, Adding a port command, Figure 178: selecting the port command action type – Kramer Electronics WP-501 User Manual
Page 105: Figure 179: selecting the command

100
K-Config - Adding Actions to a Trigger
9.2
Adding a Port Command
To add actions to a trigger (for example, to the built-in All On trigger), do the following:
1.
In the Triggers area, select the All On trigger.
2.
In the Action Editor, select the Port Command and select the desired port.
A specific driver was assigned to the selected port, therefore it is selected automatically
Figure 178: Selecting the Port Command Action Type
3.
Select the Command (for example, PWR_ON):
Note that PWR_ON is a shared command, previously defined in the Driver Manager (see
Section 5
).
Figure 179: Selecting the Command