Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 400)

Section 9. Automating Tasks with Task Master
Always enter the full path when specifying the file to execute.
Otherwise, the file may not be found or may not run as expected.
The Task Master can process only one command in a command
line. If multiple commands are required, place the entire
command sequence in a batch file and execute the batch file from
the Task Master. (If you are running Windows as a restricted user
or if you are running LoggerNet as a service, you must explicitly
set all file paths in the batch file.)
The Task Master may not be able to process certain characters on
a command line, such as the redirect (<) character. Use the
Window’s cmd function with the /c option to process the
command (e.g., cmd /c ““cora_cmd
function will carry out the command in the subsequent string and
then terminate.
Call Station – Select this check box to trigger a call to a station when a task
event is triggered. Data will be collected according to settings in the Setup
Screen for the datalogger. Use the drop-down list box to select the station that
will be called.
FTP Settings – This check box is only available when configuring an Add
After task with the Station Event Type set to After File Closed. Select this
check box to transfer the file to a designated FTP directory with the following
settings:
Host Address
The FTP server to which the file will be sent.
User ID
The username on the FTP server.
Password
The user’s password on the FTP server
Remote Folder
Selects the folder on the FTP server to which the file will be transferred.
The file will be saved to this folder under the FTP server’s FTP root
directory. Press the button to browse to the desired directory.
FTP Protocol
Use the check box to select the FTP Protocol to use. The options are FTP
(File Transfer Protocol), SFTP (SSH FTP), and FTPS (FTP over TLS).
FTP Queue Size
If an FTP fails for some reason, the file can be queued up to be sent in the
future when the issue that caused the failure has been resolved. An FTP
will only be attempted each time the task is triggered.
The FTP Queue Size determines how many files the Task Master will
keep in the queue to attempt to FTP again.
NOTES
9-10