Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 233)

Section 7. Creating and Editing Datalogger Programs
Note that outputs for a sensor don’t have to be added in the same sequence as
the measurement. You can even drag and drop the outputs to rearrange their
order. Note also that multiple outputs can be added for any one sensor. For
example, you may want to store the maximum and minimum air temperature as
well as the average.
Table-based dataloggers have a TableName field as opposed to an
array ID. There is also a check box used to store data to a PC card
or SC115, if that functionality is supported by the datalogger
model (see below for more information).
The Advanced Outputs check box in the lower left corner provides more output
options:
NOTE
7-15