Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 221)

Section 7. Creating and Editing Datalogger Programs
Short Cut was designed with extensive built-in help. Help can be accessed at
any time by pressing the F1 key. There are also Help buttons on most screens.
You can also open the Help by selecting Short Cut Help from Short Cut's Help
menu. Help for each sensor can be accessed by searching the Help Index or
pressing the Help button from the sensor form.
After generating the program, you can send it to the datalogger from the
Results tab of Short Cut’s Finish screen or from LoggerNet’s Connect Screen
or from PC400, PC200W, or RTDAQ’s Clock/Program tab.
7.2.2 Creating a Program Using Short Cut
On opening, Short Cut presents a wizard that walks you through the steps of
creating a datalogger program.
7.2.2.1 Step 1 – Create a New File or Open Existing File
To begin creating a new program, press the New Program button. To open an
existing program, press the Open Program button and select a file from the
resulting browser window.
7-3