Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 190)

Section 5. Real-Time Tools
and Run Project menu or clicking the Run-Time icon on the toolbar. This will
start the project window with RTMC Run-Time as shown in the window
below.
When the run-time display screen is started, the display components will have
a red exclamation point in the upper right corner until data is received from
LoggerNet. If data is not displayed, check to see that the data is being
collected on a schedule by LoggerNet.
Once a project file has been created, the display screen can be run without
starting the development mode window. Select Data | RTMC Run-Time from
the LoggerNet toolbar. In the Run-Time window select File | Open to select
the RTMC project screen to run.
In Run-time mode, you can print an image of the RTMC display screen by
selecting File | Print Screens. A new form to be run is selected under File |
Open.
A copy of RTMC Run-Time comes with LoggerNet. If you want to run
RTMC projects on remote computers, additional copies of RTMC Run-Time
can be purchased separately. One copy is required for each computer on which
RTMC Run-Time will be used. As noted above, when running RTMC Run-
Time on a remote computer, the host computer must have Remote Connections
enabled (LoggerNet Toolbar, Tools | Options | Allow Remote Connections).
5-54