Campbell Scientific LoggerNet Datalogger Support Software - Manual (Page 395)

Section 9. Automating Tasks with Task Master
the file name ahead of time. Therefore, the %F option can be used to insert
the file name in the command line options.
• After Any Data Collected – After data is collected by any means, and the
call is terminated for any reason (success or failure). The task is triggered
by a scheduled collection, by using a Collect Now button, a datalogger
call-back, or another task that calls the associated station which causes any
data to be collected.
• After File Retrieved – After a file is retrieved based on the datalogger’s
File Retrieval tab in the Setup Screen.
When the station’s File Retrieval Mode (on the Setup Screen’s File
Retrieval tab) is set to Follow Scheduled Data Collection, the task is
triggered by a scheduled collection, by using a Collect Now button, by a
datalogger call-back, or by another task that calls the associated station
and causes a file retrieval. An attempt to retrieve the file(s) will be made at
the scheduled time, only if scheduled collection is enabled. However,
when a manual poll/Collect Now is performed, an attempt to retrieve the
file(s) will be made regardless of whether scheduled collection is enabled
or not.
When the station’s File Retrieval Mode is set to New Schedule, only the
new schedule will trigger file retrieval and thus, the task. Attempts to
retrieve the file(s) will be made following the new schedule, whether
scheduled collection is enabled or not.
9-5