HP XP Continuous Access Software - Manual (Page 76)

76 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
User-settable environment variables
When activating RM or initiating a command, you can specify any of the
following environment variables:
• RM Environment Variables
• RM command Environment Variables
• RM instance Environment Variables
• environment variable for BC commands
RM environment variables
$HORCM_CONF
Specifies the name of the RM configuration file.
Default: /etc/horcm.conf
$HORCM_LOG Specifies the name of the RM log directory.
Default: /HORCM/log/curlog
$HORCM_TRCSZ
Specifies the size of the RM trace file in kilobytes. The
file size of 1 MB is used by default if no size is
specified.
You cannot change the trace file size of RM in real time
using the horcctl command.
$HORCM_TRCLVL
Specifies the RM trace level (between 0 and 15). If you
specify a negative value, the trace mode is canceled. If
you do not specify a level, tracing becomes level 4 by
default.
You can change the trace level of RM in real time by
using the horcctl –c –l command.
$HORCM_TRCBUF
Specifies the RM trace mode. If you specify this