HP XP Continuous Access Software - Manual (Page 247)

247
BNM displays whether this validation is disabled or
enabled. If BNM is 0 then this validation is disabled.
–v gflag
Displays the flags for guarding the target volumes.
Example
raidvchkdsp -g vg01 -fd -v gflag
Group PairVol Device_File Seq# LDEV# GI-C-R-W-S PI-C-R-W-S R-Time
vg01 oradb1 c4t0d2 2332 2 E E D D E E E D D E 365
vg01 oradb2 c4t0d3 2332 3 E E D D E E E D D E -
GI-C-R-W-S displays the protection flags for the target
volume. The flags are “E” for enabled and “D” for
disabled.
I: Inquiry command.
C. Read Capacity command.
R. Read command.
W. Write command.
S. Ability to become an S-VOL.
PI-C-R-W-S displays the permission flags, showing
whether the permission flags can be changed to enable.
“E” indicates that a flag can be changed to enable. “D”
indicates that it cannot.
I. “I” flag permission.
C. “C” flag permission.
R. “R” flag permission.
W. “W” flag permission.
S. “S” flag permission.
R-Time
The retention time for write protection, in days. A
hyphen (-) indicates that the retention time is “infinite.”
-v pool
Displays the capacity and the usable capacity of the
SnapShot pool corresponding to the group.