HP XP Continuous Access Software - Manual (Page 315)

Configuration file examples 315
Commands from HOSTB shown on page 311
The following examples employ RM commands from HOSTB.
• Set the HORCC_MRCF environment variable. (If C shell)
# setenv HORCC_MRCF 1
(Windows NT/2000/2003) set HORCC_MRCF=1
• Designate a group name (Oradb) on the CA environment of HOSTB:
# paircreate -g Oradb -vr
• Designate a group name (Oradb1) on the BC environment of
HOSTB:
# paircreate -g Oradb1 -vl
This command begins a pair coupling between the four pairs of
volumes designated as Oradb in the configuration definition file.
• Designate a group name and confirm pair volume state on the CA
environment of HOSTB:
# pairdisplay -g oradb –m cas
Group PairVol(L/R) (Port#,TID,LU-M), Seq#, LDEV#..P/S, Status, Seq#, P-LDEV# M
oradb1 oradev11(L) (CL1-D, 2, 1-0) 30053 268..P-VOL PAIR 30053 270 -
oradb2 oradev21(L) (CL1-D, 2, 1-1) 30053 268..SMPL ---- ----- ---- -
oradb oradev1(L) (CL1-D, 2, 1) 30053 268..S-VOL PAIR ----- 266 -
oradb oradev1(R) (CL1-A, 1, 1-0) 30053 266..SMPL ---- ----- ---- -
oradb oradev1(R) (CL1-A, 1, 1) 30053 266..P-VOL PAIR 30053 268 -
oradb1 oradev12(L) (CL1-D, 2, 2-0) 30053 269..P-VOL PAIR 30053 271 -
oradb2 oradev22(L) (CL1-D, 2, 2-1) 30053 269..SMPL ---- ----- ---- -
oradb oradev2(L) (CL1-D, 2, 2) 30053 269..S-VOL PAIR ----- 267 -
oradb oradev2(R) (CL1-A, 1, 2-0) 30053 267..SMPL ---- ----- ---- -
oradb oradev2(R) (CL1-A, 1, 2) 30053 267..P-VOL PAIR 30053 269 -