HP XP Continuous Access Software User Manual
Page 177
177
then this option splits a cascading BC volume on a
remote host (far site).
The target BC volume must be a P-VOL, and the
–E
option cannot be specified.
–g group
Specifies which group to split. The group names are
defined in the HORCM_DEV section of the RM
instance configuration file.
The command executes for the entire group unless the
–d pair_vol
argument is specified.
–h
Displays Help/Usage and version information.
–l
When the remote host is down and cannot be used, this
option enables a pairsplit from a local host.
(CA only
) Unless the –R option is specified, the target
volume of a local host must be a P-VOL.
–nomsg
Suppresses messages. If used, this argument must be
the first argument specified.
–P
(CA only
) Used to bring the primary volume forcibly
into write disabled mode. It is issued by the secondary
host to suppress data updating by the host possessing
the primary volume.
–R
(CA only) Used to bring the secondary volume forcibly
into SMPL mode. It is issued by the secondary host if
the host possessing the primary volume goes down
because of a failure or the like.
–R[S]
(CA only) Bring the secondary volume forcibly into
SMPL mode.
–R[B]
(CA only) Used to bring the secondary volume forcibly
from SMPL to PSUE mode.
–r
[w]
(CA only) Used to specify a mode of access to the
secondary volume after paired volumes are split.