HP XP Continuous Access Software - Manual (Page 109)

RAID Manager command reference 109
horcctl
Change and display RM internal trace and control parameters
Description
The horcctl command is used for maintenance (except for the –S, –D, –C,
–ND, –NC
, and –g arguments) and troubleshooting. When it is issued, the
internal trace control parameters of the RM manager and RM commands
are changed and displayed.
If the arguments –l level, –b m, –s size(KB), or –t type are not specified, the
current trace control parameters are displayed.
Syntax
horcctl –h
horcctl { –d
| –c | –l level | –b m | –q | –s size(KB) | –t type | –z | –zx }
horcctl –S
horcctl { –D | –C | –u unitid }
horcctl { –ND | –NC | –g group
}
Arguments
–h Displays Help/Usage and version information.
–d Interprets the trace control arguments (–l level, –b m,
–s size(KB) , –t type) following this argument as
parameters for RM.
–c Interprets the trace control arguments (–l level, –b m,
–t type ) following this argument as parameters for the
CA manager.
–l level Sets a trace level to the one specified in level.
The effective level is between 0 and 15.
Specifying a negative value cancels the trace mode. A
negative value n is specified as –
–n , where n is any
digit between 1 and 9. For example:
horcctl –l – –4