HP XP Continuous Access Software User Manual
Page 238
238
HP StorageWorks Disk Array XP RAID Manager: User’s Guide
Valid values for type:
redo8
Sets the parameter for validation checking as Oracle
redo log files (including archive logs) prior to Oracle9i.
This option sets bsize to 1 (512 bytes) for Solaris or 2
(1024 bytes) for HP-UX.
data8
Sets the parameter for validation checking as Oracle
data files prior to Oracle9i.
redo9
Sets the parameter for validation checking as Oracle
redo log files for Oracle9iR2 or later. This option sets
bsize
to 1 (512 bytes) for Solaris or 2 (1024 bytes) for
HP-UX.
data9
Sets the parameter for validation checking as Oracle
data files (including control files) for Oracle9iR2 later.
–vs
bsize [SLBA ELBA]
Specifies the data block size of Oracle I/O and a region
on a target volume for validation checking.
bsize
is used for specifying the data block size of Oracle
I/O, in units of 512 bytes. bsize is able to specify
between 1 (512 bytes) and 128 (64 kilobytes), but the
effective size for Oracle is between 1 (512 bytes) and
64 (32 kilobytes).
If the –vs option is also used for redo log volumes to
specify SLBA ELBA, bsize must be set to 2 for HP-UX
or 1 for Solaris.
SLBA
ELBA specifies a region defined between
Start_LBA and End_LBA on a target volume for
checking, in units of 512 bytes. The effective region is
from 1 to end-of-LU.
SLBA ELBA
can be specified in hexadecimal by
addition of 0x, or decimal.