HP XP Continuous Access Software - Manual (Page 115)

RAID Manager command reference 115
–d [g] seq# LDEV# [ MU# ]
Searches the RM instance configuration file (local
instance) for a volume that matches the specified
sequence number (seq#) and LDEV. If a volume is
found, a command is executed on the paired logical
volume (–d) or group (–dg). If the volume is contained
in two groups, the command is executed on the first
volume encountered. If MU# is not specified, it defaults
to 0.
seq# is the array serial number. seq# LDEV# can be
specified in hexadecimal (by addition of 0x) or decimal.
–g group Specifies a group name in the RM instance
configuration file.
The command executes for the entire group unless the
–d pair_vol argument is specified.
–h Displays Help/Usage and version information.
–l Executes a PVOL-takeover, which enables the P-VOL
for reading and writing by a local host without a remote
host. This argument is used when the primary volume is
in status or data fence, is not allowing writes, and is in
PSUE or PDUB state. If the primary volume is in any
other state, then a nop-takeover is executed.
The target volume of a local host must be a P-VOL.
–nomsg Suppresses messages to be displayed. It is used to
execute this command from a user program.
This argument must be specified at the beginning of the
command arguments.
–q Terminates interactive mode and exits this command.
–S Selects and executes an SVOL-takeover. The target
volume of a local host must be an S-VOL. If this
argument is specified, the –l argument is invalid.