HP XP Continuous Access Software - Manual (Page 251)

251
This option always must be specified if the –find or –p
port
option is not specified. If this option is specified,
the –s seq# option is invalid.
-pdg specifies the LUNs displayed in host view by
locating a host group for XP 128 and XP 1024 arrays.
–s seq# Specifies the serial number of the disk array on multiple
disk array connections when you cannot specify the
unit ID that is contained in the –p port option or the –v
jnl option.
This option searches the corresponding unit ID for the
seq#
and it scans the port that is specified by –p port
option.
If this option is specified, the unit ID contained in –p
port
is invalid. If this option is specified, the unit ID
contained in –v jnl is invalid.
–t target Specifies a SCSI/Fibre target ID of a specified port. If
this option is not specified, the command applies to all
targets.
–l LUN Specifies the LUN of a specified SCSI/Fibre target. If
this option is not specified, the command applies to all
LUNs.
A LUN-only specification without designating a target
ID is invalid.
–fx Displays the LDEV/STLBA/ENLBA number in
hexadecimal.
–v operation Specifies an operation that displays each parameter for
validation checking.
Valid values for operation: