HP XP Continuous Access Software - Manual (Page 159)

159
The command executes for the entire group unless the
–d pair_vol argument is specified.
–h Displays Help/Usage and version information.
–l When this command cannot use a remote host because
it is down, this option allows execution of this
command by a local host only.
The target volume of a local host must be SMPL or
P-VOL.
BC/SnapShot volumes can be specified from the
S-VOL.
–nomsg Used to suppress messages when this command is
executed from a user program.
This option must be specified at the beginning of the
command arguments.
–nowait Causes the pairing status is reported immediately.
When this option is specified, the –t and –s options are
ignored.
–q Terminates interactive mode and exits this command.
–s status Specifies the waiting status (SMPL, COPY [including
RCPY], PAIR, PSUS, or PSUE). If two or more
statuses are specified following –s, waiting occurs
according to the logical OR of the specified statuses.
This argument is not valid when the –nowait argument
is specified.
–t timeout [ interval ]
Specifies the amount of time, in one-second intervals,
to wait for the specified state. If [interval] is not
specified, the, the default value is used. This argument
is not valid when the –nowait argument is specified. If