HP XP Continuous Access Software - Manual (Page 178)

178 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
The –r option allows read-only access of the secondary
volume, –r is a default option.
The –rw option enables reading and writing from and
to the secondary volume.
–S (Optional) Used to bring the primary and secondary
volumes into SMPL mode in which pairing is not
maintained. Data consistency is only maintained if
devices are in a suspend status (PSUS). If devices are in
a pair status (PAIR), data on the secondary volume will
not be consistent and not usable.
Returned Values
This command sets either of the following returned values in exit(), which
allows you to check the execution results.
The command returns 0 upon normal termination.
A nonzero return indicates abnormal termination. For the error cause and
details, see the execution logs.
Error Codes
The table below lists specific error codes for the pairsplit command.
Category Error Code Error Message Value
Volume status
unrecoverable EX_ENQVOL Unmatched volume status within the group 236
EX_INCSTG Inconsistent status in group 229
EX_INVVOL Invalid volume status 222
EX_EVOLCE Pair volume combination error 235
EX_INVSTP Invalid pair status 228
EX_EWSUSE Pair suspended at WAIT state 234