HP XP Continuous Access Software - Manual (Page 163)

163
Syntax
pairmon
{ –D | –allsnd | –q | –resevt | –nowait | –s status . . . | –z }
Arguments
–D Selects the default report mode.
One event is reported (and cleared) if there is pairing
status transition information to be reported. If there is
no information, the command waits.
The report modes consists of three flags: –allsnd,
–resevt , and –nowait.
–allsnd Reports all pairing status transition events.
–q Terminates interactive mode and exits this command.
–resevt Reports events if there is pairing status transition
information and then resets all the events.
–nowait When this option is specified, the pairing status is
reported immediately.
–s status Specifies the waiting status (SMPL, COPY [including
RCPY], PAIR, PSUS, or PSUE). If two or more
statuses are specified following –s, waiting occurs
according to the logical OR of the specified statuses.
This argument is not valid when the –nowait argument
is specified.
–z Makes this command enter interactive mode.
(continued)
Invalid –nowait –resevt When RM does not have an event, this option reports “no
event” immediately. If multiple events exist, then it reports
one event and resets all events.
Invalid –nowait –resevt –allsnd When RM does not have an event, this option reports “no
event” immediately. If multiple events exist, then it reports
all events and resets them.
–D –nowait –resevt –allsnd Actions