HP XP Continuous Access Software - Manual (Page 138)

138 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
–q Terminates interactive mode and exits this command.
–split (BC/SnapShot only) Splits the paired volume after
completing the pairing process.
-split works differently based on the microcode
version:
XP256 microcode 52-46-xx or over
XP512 microcode 01-10-00/xx or over
XP1024/XP128
XP10000
XP12000
This option will return immediately with the
PVOL_PSUS and SVOL_COPY state changes. The
SVOL state will be changed to SVOL_SSUS after all
data is copied.
XP256 microcode 52-46-yy or under
XP512 microcode 01-10-00/xx or under:
After the command is executed, the volume status will
be PVOL_COPY and SVOL_COPY. The PVOL and
SVOL states will be changed to PVOL_PSUS and
SVOL_SSUS after all data is copied.
–vl or –vr Required. Specifies the direction of the P-VOL to
S-VOL relationship. Specifies which set of volumes, r
(remote) or l (local), is the primary (P-VOL) set. Local
disks are determined by how the HORCMINST
environment variable is set.
–vl specifies the volumes defined by the local RM
instance as the primary volumes.
–vr specifies the volumes defined by the remote RM
instance as the primary volumes while the local RM
instance controls the secondary volume.
–z Makes this command enter interactive mode.