HP XP Continuous Access Software - Manual (Page 243)

243
raidvchkdsp
Integrity checking confirmation command Data Integrity Check only
Description
The raidvchkdsp command displays the parameters for protection
checking of the specified volumes. The unit of checking for the protection
is based on the RM configuration file group.
A nonpermitted volume is shown without LDEV# information (LDEV#
information is - ).
Syntax
raidvchkdsp { –h | –q | –z | –zx | –g group | –d pair_vol –d[g] raw_device
[MU#] | –d[g] seq# LDEV# [MU#] | –f[xde] | –v operation }
Arguments
–h Displays Help/Usage and version information.
–q Terminates interactive mode and exits this command.
–z This option makes this command enter interactive
mode.
–zx (Not for use with MPE/iX or OpenVMS) This option
prevents using RM in interactive mode.
–g group Specifies a group name from the configuration
definition file.
The command is executed for the specified group
unless the –d pair_vol option is specified.
–d pair_vol Specifies a paired logical volume name from the
configuration definition file. The command is executed
only for the specified paired logical volume.
–d [g] raw_device [MU#]
Searches the RM configuration file (local instance) for
a volume that matches the specified raw device. If a
volume is found, the command is executed on the
paired volume (–d) or group (–dg).