HP XP Continuous Access Software - Manual (Page 253)

253
–v offset
Displays the range setting for data block size of Oracle
I/O and a region on a target volume for validation
checking.
Example
# raidvchkscan -p CL1-A -v offset
PORT# /ALPA/C TID# LU# Seq# Num LDEV# Bsize STLBA ENLBA BNM
CL1-A / ef/ 0 0 0 2332 1 0 1024 1 102400 9
CL1-A / ef/ 0 0 1 2332 1 1 1024 1 102400 9
CL1-A / ef/ 0 0 2 2332 1 2 1024 1 102400 9
CL1-A / ef/ 0 0 3 2332 1 3 1024 1 102400 9
CL1-A / ef/ 0 0 4 2332 1 4 1024 1 102400 9
–v Bsize
Displays the data block size of Oracle I/O, in units of
bytes.
STLBA displays the Start of LBA on a target volume,
in units of LBAs.
ENLBA displays the End of LBA on a target volume,
in units of LBAs. If STLBA and ENLBA are both zero,
all blocks are checked.
BNM displays whether this validation is disabled or
enabled. If BNM is 0 then this validation is disabled.
-v pool (SnapShot only)
Displays the capacity and the usable capacity of the
SnapShot pool corresponding to the group.
Example
# raidvchkscan -v pool -p CL2-d-0
PORT# /ALPA/C TID# LU# Seq# Num LDEV# Bsize Available Capacity
CL2-D-0 /e4/ 0 2 0 62500 1 160 2048 100000 1000000000
CL2-D-0 /e4/ 0 2 1 62500 1 161 2048 100000 1000000000
Bsize : This displays the data block size of the pool, in units of
block(512bytes).