HP XP Continuous Access Software - Manual (Page 168)

168 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
–FCA [MU#] Used to resync a CA P-VOL that is also a BC P-VOL.
If the –l option is specified, this option resynchronizes a
cascading CA volume at the local host (near site). If no
–l
option is specified then this option re-synchronizes a
cascading CA volume at the remote host (far site).
The target CA volume must be a P-VOL and the
–swap [s | p] option cannot be specified.
The MU# specifies the cascading mirror descriptor for
CA-Journal.
–FBC [MU#] Used to forcibly resync a BC pair whose P-VOL is a
CA S-VOL. If the –l option is specified, this option
resynchronizes a cascading BC volume on a local host
(near site). If no –l option is specified, this option
resynchronizes a cascading BC volume on a remote
host (far site).
The BC volume designated by the MU# must be a
P-VOL.
–g group Specifies a group name to resynchronize. The group
names are defined in the HORCM_DEV section of the
RM instance configuration file.
The command is executed for the entire group unless
the –d pair_vol argument is specified.
–h Displays Help/Usage and version information.
–l Allows a local host (connected to the P-VOL) to
resynchronize P-VOL to S-VOL even though the
remote host is down.
–nomsg Used to suppress messages when this command is
executed from a user program.
This option must be specified at the beginning of the
command arguments
–q Terminates interactive mode and exits this command.