HP XP Continuous Access Software - Manual (Page 204)

204 HP StorageWorks Disk Array XP RAID Manager: User’s Guide
This option can be used with the –fx option to display
the LDEV numbers in hexadecimal format.
–find [op] [MU#] Used to execute the specified [op] using a raw device
file provided by STDIN. See next entries.
–find conf [MU#] [–g name]
Used to display the port, target ID, and LUN in the
horcm.conf
file by using a special raw device file
provided via STDIN.
If the target ID and LUN are unknown for the target
device file, then you will have to start RM without a
description for HORCM_DEV and HORCM_INST.
This option allows you to use the –fx option to display
the LDEV numbers in hexadecimal format.
The –g name option is used to specify the name to be
used for dev_group in the horcm.conf file. If this
option is not specified, the group applies VG as the
default.
–find sync [MU#] [–g name]
Flushes the system buffer of the logical drive
corresponding to a –g name (dev_group) in the RM
configuration file. The dev_group name is provided via
STDIN through the KEY WORD($Volume,$LETALL,
$Physical).
The –g name option is used to specify the name to be
used for dev_group in the horcm.conf file. If this
option is not specified, then the system buffers
associated with all groups for the local instance are
flushed.
If the logical drive corresponding to a –g name is not
open for any application, then the logical drive system
buffer is flushed and the drive is unmounted.