Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 93)

75
CATC BTT RAINER 2.20 A PPENDIX A
User’s Manual
A.1.19 Remote_Name_Request
Remote_Name_Request is used to obtain the user-friendly name of another Bluetooth
device.
The BD_ADDR command parameter is used to identify the device for which the
user-friendly name is to be obtained. The Page_Scan_Repetition_Mode and
Page_Scan_Mode command parameters specify the page scan modes supported by the
remote device with the BD_ADDR. This is the information that was acquired during the
inquiry process. The Clock_Offset parameter is the difference between its own clock and
the clock of the remote device with BD_ADDR. Only bits 2 through 16 of the difference are
used and they are mapped to this parameter as bits 0 through 14 respectively. A
Clock_Offset_Valid_Flag, located in bit 15 of the Clock_Offset command parameter, is
used to indicate if the Clock Offset is valid or not.
Return Events
Reject_Connection_Request_Complete
Command Parameters Examples Comments
BD ADDR 0x010203040506
Page Scan Rep Mode 0x0 0x00=R0; 0x01=R1; 0x02=R2
Page Scan Mode 0x0 0x00=Mandatory Page Scan
Mode
0x01=Optional Page Scan Mode
I
0x02=Optional Page Scan Mode
II
0x03=Optional Page Scan Mode
III
Clock Offset 0x0 Bit Format:
Bit 14.0 = Bit 16.2 of
CLKslave -
CLKmaster.
Bit 15 = Clock_Offset_
Valid_Flag where
0= Invalid Clock Offset
1=Valid Clock Offset
Return Events
Remote_Name_Request_Complete
Remote_Name_Request_Error