Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 168)

150
CATC BTT RAINER 2.11 C HAPTER
User’s Manual
Return value
• Command Complete event will return after the operation has started.
• Disconnection Complete event will return after the operation has com-
pleted: LMP_Detach and LMP_Features_Req are sent
Comments
This command will start a modified ACL disconnection procedure in order
to verify that the IUT closes the link according to the TP/LIH/BV-04-C test
case. During the procedure, LMP_Detach is sent, and after 3 seconds
LMP_Features_Req PDUs is sent.
Example
HCICatcGetParkMode
HCICatcGetParkMode()
Return
• Command Complete event will return after the operation has com-
pleted: connection is placed in the active mode
Used in Test Cases
Parameter Values Description Parameter
N/A N/A
Event Parameter Values
Num_Hci_Command_Packets
Command_Opcode 0xFC68
Status 0x00 – Success. Indicates successful start of the operation.
0x01- Failure
ParkMode
1 Byte
0 - parking by PM_ADDR
1 - parking by BD_ADDR
2-0xFF - reserved
Test Case Description
TP/LIH/BV-26-C Need to exit park mode by sending LMP_unpark_BD_ADDR_req.