Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 68)

50
CATC BTT RAINER 2.20 C HAPTER 5
User’s Manual Command Generator
Status Commands
Testing Commands
CATC-Specific Commands
Read_Local_Supported_Features N/A
Read_Local_Version_Information N/A
Table 5-8: Unsupported HCI Informational commands
Commands
All Informational commands are supported in Command Generator.
Table 5-9: Supported HCI Status commands
Commands
Read_Failed_Contact_Counter
Reset_Failed_Contact_Counter
Table 5-10: Unsupported HCI Status commands
Commands
Get_Link_Quality
Read_RSSI
Table 5-11: Supported HCI Testing commands
Commands Parameters
Enable_Device_Under_Test_Mode N/A
Read_Loopback_Mode N/A
Write_Loopback_Mode Loopback_Mode
Note: The Supported HCI Testing commands shown above are part of the “TCI” dialog.
Table 5-12: Unsupported HCI Testing commands
Commands
All Testing commands are supported in Command Generator.
Table 5-13: Supported CATC-Specific HCI commands
Commands Parameters
CATC_Change_Headset_Gain Device
Gain
CATC_Decrease_Power_Request HCI_Handle
Table 5-7: Supported HCI Informational commands (Continued)
Commands Parameters