Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 270)

252
CATC BTT RAINER 2.11 C HAPTER
User’s Manual
B.9 L2CAP Commands
L2CAPConfigurationRequest
L2CAPConfigurationRequest(FlushTimeout, ServiceType,
TokenRate, TokenBucketSize, PeakBandwidth, Latency,
DelayVariation)
Parameter Meaning Default Value Comments
FlushTimeout Amount of
time that the
sender will
attempt trans-
mission before
flushing the
packet
0xFFFF Time is in milliseconds.
ServiceType The required
level of ser-
vice
0x01 Possible values: 0x00 (no traffic), 0x01 (best
effort),0x02 (guaranteed), Other (reserved)
TokenRate The rate at
which traffic
credits are
granted
0x00000000 0x00000000: no token rate is specified.
0xFFFFFFFF: a wild card value that matches the
maximum token rate.
Rate is in bytes per second.
TokenBucket
Size
The size of the
token bucket
0x00000000 0x00000000: no token bucket is needed.
0xFFFFFFFF: a wild card value that matches the
maximum token bucket.
Size is in bytes.
PeakBandwidth A value that
limits the
speed at which
packets may
be sent con-
secutively
0x00000000 The default value indicates that the maximum
bandwidth is unknown.
The speed is in bytes per second.
Latency The maxi-
mum delay
that is accept-
able between
transmission
of a bit and its
initial trans-
mission over
the air
0xFFFFFFFF The default value represents a Do Not Care.
The delay is in milliseconds.