A.15.7 registerbnep, A.15.8 deregisterbnep, A.15.9 setcontroltimeout – Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual User Manual
Page 148: A.16 tci commands, A.16.1 catc_entertestmode, A.16.2 catc_testcontrolmaster, Registerbnep deregisterbnep setcontroltimeout, Tci commands, Catc_entertestmode catc_testcontrolmaster
130
CATC BTT
RAINER
2.20
A
PPENDIX
A
User’s Manual
A.15.7 RegisterBNEP
A.15.8 DeregisterBNEP
A.15.9 SetControlTimeout
A.16 TCI Commands
A.16.1 CATC_EnterTestMode
This command puts a remote slave device into test mode.
A.16.2 CATC_TestControlMaster
Enter Test Mode as a master device and start the test according to specified parameters.
Command Parameters
Examples
Comments
NA
Command Parameters
Examples
Comments
NA
Command Parameters
Examples
Comments
BNEP_ADDR
Timeout
Command Parameters
Examples
Comments
N/A
Return Events
Command Status: Will return after the operation has started.
Command Complete: Will return after the operation has completed.
Command Parameters
Examples
Comments
TestScenario
Other Parameters in SetErrors dialog (see
screenshot below)
Return Events
Command Status: Will return after the operation has started.
Command Complete: Will return after the operation has completed.