A.5 status commands, A.5.1 read_failed_contact_counter, A.5.2 reset_failed_contact_counter – Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual User Manual
Page 114: A.6 hci testing commands, A.6.1 enable_device_under_test_mode, A.6.2 read_loopback_mode, Status commands, Hci testing commands, Enable_device_under_test_mode read_loopback_mode
96
CATC BTT
RAINER
2.20
A
PPENDIX
A
User’s Manual
A.5 Status Commands
A.5.1 Read_Failed_Contact_Counter
A.5.2 Reset_Failed_Contact_Counter
A.6 HCI Testing Commands
A.6.1 Enable_Device_Under_Test_Mode
The Enable_Device_Under_Test_Mode command will allow BTTrainer to enter test mode
via LMP test commands. BTTrainer issues this command when it wants to become the DUT
for the Testing scenarios as described in the Bluetooth Test Mode.
A.6.2 Read_Loopback_Mode
Read_Loopback_Mode will read the value for the setting of the BTTrainer Host
Controller’s Loopback_Mode. The setting of the Loopback_Mode will determine the path
of information.
Command Parameters
Examples
Comments
HCI_Handle
Command Parameters
Examples
Comments
HCI_Handle
0x0001
Command Parameters
Examples
Comments
N/A
Return Events
Enable_Device_Under_Test_Mode_Complete
Enable_Device_Under_Test_Mode_Error
Command Parameters
Examples
Comments
N/A
Return Events
Read_Loopback_Mode_Complete
Read_Loopback_Mode_Error