Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 46)

28
CATC BTT RAINER 2.20 C HAPTER 4
User’s Manual Profile Wizard
Note: If you cannot establish a connection, you can re-attempt the connection by
either pressing Back and re-running the previous two steps, or by pressing the
Connect button again.
Note: The Speaker and Microphone Volume levels can be adjusted by moving the
sliders up or down. The level is indicated by a number, from 0 to 15, to the
left of each slider.
Step 4
To verify that BTTrainer and the Bluetooth device are successfully
connected, speak into the microphone on one device and listen for audio on
the other.
At this point, the audio signal should transfer to the headset. Listen to the
headset to see if the data transfer is successful.
Step 5
(Optional) Click the Disconnect button on the Connection Status screen to
close the connection.
The connection between BTTrainer and the device will terminate, and the
Connect button will again be available. Selecting Connect will reestablish
the connection.
4.2.7 Connect to Device: LAN
This section explains how to configure BTTrainer to establish an RFCOMM connection to
a device that uses the Local Area Network Access profile.
Note: To connect to a device that uses the LAN profile, you will need to install the virtual COM port driver
that is included with the BTTrainer installation. For instructions, See “Installing the Virtual COM Port
Driver” on page 39.
Step 1 Complete steps 1-6 in Section 4.2, “Connecting to Devices” on page 21.
Step 2
Select LAN from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
BTTrainer to switch roles during the connection.
Step 3
Click Next.
The Wizard will advance to the Connection Status screen.
4.2.8 Connect to Device: Object Push
BTTrainer can be configured to transfer files to a Bluetooth wireless device that complies
with the Object Push profile. This section shows how to configure BTTrainer to connect and
transfer files to a Bluetooth device that supports Object Push.
Step 1 Complete steps 1-6 in Section 4.2, “Connecting to Devices” on page 21.
Step 2
Select Object Push from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
BTTrainer to switch roles during the connection.
Step 3
Press Next.
The Select Data for Transfer screen will open: