Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 33)

15
CATC BTT RAINER 2.20 C HAPTER 3
User’s Manual Local Device Manager
3.2.1 Security Mode
There are three Bluetooth security modes: security mode 1, security mode 2, and security
mode 3. Another option is not to use a security mode at all.
• Security mode 1 is the non-secure mode. When in this mode, devices do not initiate
security procedures.
• Security mode 2 is service-level enforced security. Devices in this mode initiate security
procedures after L2CAP channel establishment has ocurred.
• Security mode 3 is link-level enforced security. A device in this mode will initiate secu-
rity procedures before L2CAP channel establishment has ocurred.
To set the security mode that BTTrainer will use:
Step 1
Select a security mode from the drop-down list.
Note: Security mode 2 is not currently supported in BTTrainer.
Step 2
(Optional) Check or uncheck “Use encryption” to configure whether
BTTrainer will implement encryption when communicating with other
devices.
Step 3
Click Apply to apply the settings, or click OK to apply the settings and close
the Local Device Manager.
3.2.2 Bonding Mode
Bluetooth bonding causes two devices to create, exchange, and store a common link key.
The devices store the link key and use it for authentication during future connections.
BTTrainer supports only the general bonding mode. BTTrainer sets the bonding mode based
on the security mode that has been selected.
Bonding is applied only if security mode 3 has been selected in the Local Device Manager.
3.2.3 PIN Codes
You may define the PIN codes that BTTrainer should use for specific devices.
Add a PIN Code
Note: PIN codes may also be added by specifying them when using Profile Wizard to connect to a device.
See Section 4.2, “Connecting to Devices” on page 21 for more information.
Step 1
Click Add.
The Add PIN Code dialog will open.
Step 2 Enter the Bluetooth device address (BD_ADDR) in the first text box. It must
be entered in hexadecimal, containing from 1-12 digits.
Note: To enter a default PIN code, enter the word “Default” instead of a
BD_ADDR.