Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 42)

24
CATC BTT RAINER 2.20 C HAPTER 4
User’s Manual Profile Wizard
To send data:
Note: A modem driver must be installed on the virtual COM port in order to use an
external application to send data through BTTrainer. See “Install a Modem
Driver on the Virtual COM Port” on page 40 to find out how to install the
driver. Once the driver is installed, you must configure the external
application to use that driver.
Note: An external dial-up communications application (such as Windows Dial-Up
Networking) must be installed on the host computer in order to perform this
operation.
Open the application and send the data. It will use the modem driver on the
virtual COM port to send the data to the Dial-Up Gateway device through
BTTrainer.
Enable or disable event logging:
You can configure BTTrainer to write incoming or outgoing data to the Event
Log by checking or unchecking the “Log Incoming Data” and “Log
Outgoing Data” options.
4.2.2 Connect to Device: Fax Gateway
The Fax Gateway option allows you to use a fax application to send to data to BTTrainer via
a virtual COM port. BTTrainer then uses Bluetooth to send the data to a device that uses the
Fax Gateway profile to send data over a fax modem.
Before attempting this, you must install the virtual COM port driver that is included with the
BTTrainer installation. For instructions, see “Installing the Virtual COM Port Driver” on
page 39.
Step 1
Complete steps 1-6 in Section 4.2, “Connecting to Devices” on page 21.
Step 2
Select Fax Gateway from the list on the Select Profile screen.
(Optional) Select the Allow Role Switch option on the screen to enable
BTTrainer to switch roles during the connection.
Step 3
Click Next.
BTTrainer will establish a connection to the specified device.
Step 4
You can now send individual commands to the Fax Gateway device or use
an external fax application to send data over the virtual COM port.
To send individual commands:
Enter a command in the combo box and press the Send Cmd button. Each
command that you enter during the current session will be added to the
drop-down list in the combo box.
To send fax data: