3 emulating devices, Emulating devices – Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual User Manual
Page 50
32
CATC BTT
RAINER
2.20
C
HAPTER
4
User’s Manual
Profile Wizard
Note: A modem driver must be installed on the virtual COM port in order to use an
external application to send data through BTTrainer. See “Install a Modem
Driver on the Virtual COM Port” on page 40 to find out how to install the
driver. Once the driver is installed, you must configure the external
application to use that driver.
Open the application and send the data. It will use the modem driver on the
virtual COM port to send the data to the Serial Port device through
BTTrainer.
4.3 Emulating Devices
Choosing the “Emulate Device” option on the opening screen of Profile Wizard allows you
to configure BTTrainer to emulate a Bluetooth wireless device. This option causes
BTTrainer to act as a slave device.
Step 1
Open Profile Wizard and click the Emulate Device button.
The Select Profile screen will open.
Step 2
Select a profile from the list and click Next.
You will advance to the Configure Security screen.
Step 3
Select the security option that you would like to apply for the device.
• Do not apply authentication and encryption.
Authentication and encryption will not be used.
• Apply authentication and encryption.
The default authentication and encryption settings will be used.
• Use current authentication/encryption settings.
The authentication and encryption settings that are currently set in the
Local Device manager will be used.
• Display the Local Device Manager so I can configure security and verify
PIN codes myself.
This option allows you to access the Local Device Manager to manually
enter the security settings. If you choose this option, press Next to open
the Local Device Manager. When you close the dialog, Step 4 will be
performed automatically.
Step 4
Press Next.
At this point, please refer to the section that describes the setup for the
particular profile that the target device uses:
• Section 4.3.1, “Emulate Device: Dial-Up Gateway” on page 33
• Section 4.3.2, “Emulate Device: Fax Gateway” on page 34
• Section 4.3.3, “Emulate Device: File Transfer” on page 34