Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 56)

38
CATC BTT RAINER 2.20 C HAPTER 4
User’s Manual Profile Wizard
For Filter Network Type Set Message, the Start and End Ranges may be
in the format nnnn or 0xnnnn. For the Filter Multicast Address Set
Message, the Start and End Ranges can be in the format nnnnnnnnnnnn
or 0xnnnnnnnnnnnn.
• Send Packet: Use this to send an ethernet packet to the remote device.
The types of ethernet packets that can be sent are General, Compressed,
Compressed Source Only and Compressed Destination Only.
Note: Depending on your network settings for ‘CATC Bluetooth Trainer PAN Virtual NIC’ Local
Connection, Windows may create additional network traffic over this connection. Check your
network properties for ‘CATC Bluetooth Trainer PAN virtual NIC.’
4.3.10 Emulate Device: PAN - NAP
Note: To connect to a device that uses the PAN profile, you must install the virtual network driver that is
included with the BTTrainer installation. For instructions, see Section 4.7, “Installation of Network
Driver,” on page 41.
Step 1 Complete Steps 1-4 in Section 4.3, “Emulating Devices” on page 32.
Step 2
In the Select Profile screen, select PAN-NAP, and click Next.
The Emulation Status screen will open, indicating that BTTrainer has been
configured to emulate a Bluetooth device that supports the PAN-NAP profile
and is awaiting connection from a device. It is now ready to receive files.
Step 3 Click Next.
• Send Control Packet: Use this to select a filter control message to send
to the remote device. You may send either a Filter Network Protocol Type
message or a Filter Multicast Address Type message control packet to the
remote device.
Start Range and End Range: Start Range defines the beginning of the
range, and End Range defines the end of the range. Only the protocol
types or multicast addresses that fall within the range will be sent by the
remote device; all other types or addresses will be filtered out.
For Filter Network Type Set Message, the Start and End Ranges may be
in the format nnnn or 0xnnnn. For the Filter Multicast Address Set
Message, the Start and End Ranges can be in the format nnnnnnnnnnnn
or 0xnnnnnnnnnnnn.
• Send Packet: Use this to send an ethernet packet to the remote device.
The types of ethernet packets that can be sent are General, Compressed,
Compressed Source Only and Compressed Destination Only.
Note: Depending on your network settings for ‘CATC Bluetooth Trainer PAN Virtual NIC’ Local
Connection, Windows may create additional network traffic over this connection. Check your
network properties for ‘CATC Bluetooth Trainer PAN virtual NIC.’