Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 196)

178
CATC BTT RAINER 2.11 C HAPTER
User’s Manual
• “Success”
• “Failure”
HCI handle (element 1) is the handle for the ACL connection.
Flags (element 2) is a one-byte value reserved for future use.
Service type (element 3) is the one-byte service type. (0=No traffic; 1=Best
effort; 2=Guaranteed.)
Token rate (element 4) is the four-byte token rate value in bytes per second.
Peak bandwidth (element 5) is the four-byte peak bandwidth value in bytes
per second.
Latency (element 6) is the four-byte latency value in microseconds.
Delay variation (element 7) is the four-byte delay variation value in micro-
seconds.
Comments
This command is used to specify Quality of Service parameters for the con-
nection.
Example
QoS = HCIQoSSetup('00803713BDF0', 2, 0, 0, 0x12345678,
0x23456789);
Trace("Merlin's Wand Link QoS Setup returned: ", QoS[0],
"\n");
if (QoS[0] == "Success")
{
Trace(" Connection Handle : 0x", QoS[1], "\n");
Trace(" Flags : 0x", QoS[2], "\n");
Trace(" Service Type : 0x", QoS[3], "\n");
Trace(" Token Rate : 0x", QoS[4], "\n");
Trace(" Peak Bandwidth : 0x", QoS[5], "\n");
Trace(" Latency : 0x", QoS[6], "\n");
Trace(" Delay Variation : 0x", QoS[7], "\n\n");
}
HCIReadAuthenticationEnable
HCIReadAuthenticationEnable()
Parameter Meaning Default Value Comments
N/A