Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 123)

105
CATC BTT RAINER 2.20 A PPENDIX A
User’s Manual
A.7.19 CATC_Sco_Parameter_Change_Response
Configure local device to accept or reject an incoming request to change SCO parameters.
Used in Test Cases
A.7.20 CATC_Select_SCO_Connection
This command will select current SCO connection for up to three SCO connections. Only
the incoming voice traffic (Rx Bluetooth packets) of the current SCO connection will be
sent to the PCM CODEC. The outgoing voice traffic (Tx Bluetooth packets) of the current
SCO connection is taken from the PCM CODEC or is set according to the "Data_Pattern"
parameter. The source - PCM CODEC or "Data_Pattern" parameter - is selected by the
"Data_Path" parameter. By default, the current SCO connection is the one that was
established first. If the current SCO connection is disconnected and there is another one or
two SCOs, the next current SCO connection is selected according to the following rules: if
only one SCO connection remains, it is selected; if there are two SCO connections, one of
Command Parameters Examples Comments
Mode
Return Events
Command Complete
Test Case
TP/LIH/BV-56-C