Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 37)

19
CATC BTT RAINER 2.20 C HAPTER 3
User’s Manual Local Device Manager
• 0x00: Encryption disabled
• 0x01: Encryption only for point-to-point packets
• 0x02: Encryption for both point-to-point and broadcast packets
• 0x03–0xFF: Reserved
• PIN_Response_Enable — Specifies whether BTTrainer will supply PINs when
requested during authentication. Possible values:
• 0x00: Device will not supply PINs when requested during authentication.
• 0x01: Device will supply PINs when requested during authentication.
• Num_Supported_IACs — The number of Inquiry Access Codes (IACs) that BTTrainer
can listen for at the same time during an Inquiry Scan.
• CBuffer_Size — The maximum size of HCI SCO and ACL data packets supported by
the BTTrainer Host Controller, as well the the maximum number of such packets that
BTTrainer can store in its data buffer. Included parameters:
• HC_ACL_Data_Packet_Length: The maximum length, in bytes, of HCI ACL data
that BTTrainer can accept in one packet.
• HC_SCO_Data_Packet_Length: The maximum length, in bytes, of HCI SCO data
that BTTrainer can accept in one packet.
• HC_Total_Num_ACL_Data_Packets: The maximum number of HCI ACL data
packets that the BTTrainer Host Controller can store in its data buffer.
• HC_Total_Num_SCO_Data_Packets: The maximum number of HCI SCO data
packets that the BTTrainer Host Controller can store in its data buffer.
• Local_Supported_Features — A list of the supported features for BTTrainer.