Teledyne LeCroy BTTracer_Trainer - BTTrainer Users Manual - Manual (Page 64)

46
CATC BTT RAINER 2.20 C HAPTER 5
User’s Manual Command Generator
5.3 Commands Available in Command Generator
The following tables summarize the commands in Command Generator.
For detailed descriptions of the commands, see Appendix A: Command Generator
Command Descriptions, on page 83.
Note: “N/A” means Not Applicable. This indicates that the specified command does not have a parameter.
5.3.1 HCI Commands
Link Control Commands
Two sections of Link Control Commands are presented. The first section lists commands
that are supported by BTTrainer. The second section presents commands that are not
supported.
Table 5-1: Supported HCI Link Control commands
Commands Parameters
Accept_Connection_Request Request_Role_Switch
Add_SCO_Connection HCI_Handle
Packet Type
Authentication_Requested HCI_Handle
Change_Connection_Link_Key HCI_Handle
Change_Connection_Packet_Type HCI_Handle
Packet_Type
Create_Connection BD_ADDR
Packet_Type
Page_Scan_Rep_Mode
Page_Scan_Mode
Clock_Offset
Allow_Role_Switch
Disconnect HCI_Handle
Exit_Periodic_Inquiry_Mode N/A
GetSCOConnection N/A
Inquiry Inquiry_Length
Num_Responses
LAP
Inquiry_Cancel N/A
Master_link_Key Key_Flag
Periodic_Inquiry_Mode Max Period Length
Min Period Length
Inquiry Length
Num of Responses
LAP
PIN_Code_Request_Negative_Reply BD_ADDR